Charger V8-5.7L (2008)
3. Slide caliper over brake pads and onto caliper adapter (3).
CAUTION: Extreme caution should be taken not to crossthread caliper guide pin bolts (2) when they are installed.
NOTE: Before installing caliper guide pin bolts, clean guide pin bolt threads and apply Mopar(R) Lock & Seal Adhesive or equivalent.
4. Align caliper mounting holes with guide pins, then install guide pin bolts (2). While holding guide pins from turning, tighten bolts to 31 Nm (23 ft.
lbs.).
5. Install banjo bolt (4) attaching brake hose (3) to caliper (1). Install NEW washers (2) on each side of hose fitting as banjo bolt is placed through
fitting. Thread banjo bolt into caliper and tighten to 50 Nm (37 ft. lbs.).
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See:
Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
