Charger V8-5.7L (2008)
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
10. Bleed (1) base brake hydraulic system as necessary. See: Brake Bleeding
CAUTION: If NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first
brake applications.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake pads. If NEW brake pads are installed, they
need to be properly burnished. See: Brake Pad/Service and Repair/Procedures/Brake Pads - Brake Pad Burnishing
Rear - SRT8
INSTALLATION
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary. See: Brake Pad/Service and
Repair/Procedures/Brake Pads - Inspection
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block or used brake pad (not to be reused) over piston before installing C-clamp to avoid damaging piston.
2. If brake pads need to be installed in caliper before installation, See: Brake Pad/Service and Repair/Removal and Replacement/Brake Pads -
Installation.
