Charger V8-5.7L (2008)
4. Rotate caliper upward (1), exposing brake pads (2 and 5). Use care not to overextend brake hose when doing this or damage may occur.
5. Remove inboard (2) and outboard (5) brake pads from caliper adapter (4).
6. If necessary, remove anti-rattle clips (3) from upper and lower abutments of adapter (4).
Rear
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution.
1. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
NOTE: Perform steps 2 through 6 on each side of the vehicle.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance
between shoes and rotor to easily remove caliper from knuckle. This can usually be accomplished before guide pin bolts are removed by
grasping rear of caliper and pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may get
damaged.
