Charger V8-5.7L (2008)
be performed by the Police agency operating the vehicle so it can be performed in a safe controlled environment. This information is covered in the
Police Package Owners Manual Supplement which was supplied when the vehicle was originally delivered.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes. If the vehicle is equipped with the
Police Package, a burnish procedure must be followed (Refer to preceding Caution).
Rear
INSTALLATION
NOTE: Perform steps 1 through 7 on each side of the vehicle.
1. Completely retract caliper piston back into bore of caliper. To do so:
a. Remove fluid reservoir cap.
b. Use hand pressure or a C-clamp may be used to retract piston, first placing a wood block over piston before installing C-clamp to avoid
damaging piston.
c. Install fluid reservoir cap.
2. If removed, attach anti-rattle clips (1) to upper and lower abutments of adapter (4).
3. Install NEW inboard (2) and outboard (3) brake pads on caliper adapter (4). NEW Inboard and outboard pads are interchangeable.
4. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
5. Rotate caliper upward, aligning upper mounting boss with upper guide pin.
NOTE: Before installing caliper guide pin bolts, clean guide pin bolt threads and apply Mopar(R) Lock & Seal Adhesive or equivalent.
6. Install upper caliper guide pin bolt (1). While holding guide pin (3) stationary tighten bolt to 31 Nm (23 ft. lbs.).
