Charger V8-5.7L (2008)
1. Install the speed control switch (1) to steering column control module (2) (SCCM).
2. If equipped with ESP , install the steering angle sensor (1) and phillips head screw (2) to SCCM. Tighten phillips head screw to.7 Nm (6 in. lbs.).
If not equipped with ESP , install the plastic insert and phillips head screw to steering column. Tighten phillips head screw to.7 Nm (6 in. lbs.).
CAUTION: DO NOT fully install one of the clockspring T10 Torx screws. Leave one clockspring T10 Torx screw out far enough to stop the
clockspring from rotating. This is necessary to keep the clockspring centered when installing to the steering shaft. Torque is critical on the
clockspring T10 torx screws, make sure the clockspring T10 Torx screws are torqued to specification.
3. Install the clockspring and two T10 Torx screws (1), leave the remaining screw out far enough to stop the clockspring from rotating. Tighten T10
Torx screws to.7 Nm (6 in. lbs.).
