Charger V8-5.7L (2008)
WARNING: To service the speed control switch, the entire assembly that houses the speed control switch must be removed from the column.
This must be done due to the clockspring passing through the assembly and into the self docking connector. Failure to remove the this assembly
could damage the pins of the clockspring during installation and prevent the airbag system from operating properly.
6. Back out set screw (1) through the access hole (3) in bottom of steering column control module (SCCM) (2) and remove SCCM.
7. If equipped with ESP , remove phillips screw (2) and steering angle sensor (1) from SCCM. If not equipped with ESP , there will be a plastic
insert there for strengthening of the SCCM that will lift right out.
