Charger V8-5.7L (2008)
Crankshaft Main Bearing: Specifications
5.7L ENGINE
CRANKSHAFT MAIN BEARING BOLT TORQUE SEQUENCE
Clean and oil all cap bolts. Install all cap bolts and alternately tighten in two steps using the following sequence.
-
Step 1 - 27 Nm ( 20 ft. lbs.).
-
Step 2 - Turn main cap bolts an additional 90°.
-
Install the crossbolts with new washer/gasket. Starting with crossbolt A, tighten each crossbolt to 28 Nm ( 21 ft. lbs.).
-
Repeat crossbolt tightening procedure.
