Charger V8-5.7L (2008)
Drive Belt Tensioner: Service and Repair
Accessory Drive Belt Tensioner - Installation
5.7L/6.1L ENGINE
1. Install tensioner bolt (2) to tensioner (1). Tighten bolt to 34 Nm (40 ft. lbs.) torque.
2. Install accessory drive belt See: Drive Belt/Service and Repair/Removal and Replacement/Accessory Drive Belt - Installation.On all engines, the
tensioner (1) is equipped with an indexing tang on back of tensioner and an indexing stop on tensioner housing. If a new belt is being
installed, tang must be within approximately 6 - 8mm (0.24 - 0.32 in.) of indexing stop (i.e. tang is approximately between the two
indexing stops). Belt is considered new if it has been used 15 minutes or less.
3. Check belt indexing marks.
