Charger V8-5.7L (2008)
REMOVAL
NOTE: LHD model shown. RHD model similar.
1. Remove the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Removal.
2. Remove the two screws (1) that secure the floor console duct (2) to the center floor panel (3).
3. Disconnect the floor console duct from the floor distribution duct (4) and remove the floor console duct from the vehicle.
Floor Console Ducts - Installation
INSTALLATION
NOTE: LHD model shown. RHD model similar.
1. Position the floor console duct (2) into the vehicle.
2. Connect the floor console duct to the floor distribution duct (4).
3. Install the two screws (1) that secure the floor console duct to the center floor panel (3). Tighten the screws to 2.2 Nm (20 in. lbs.).
4. Install the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation.
Floor Ducts - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
NOTE: LHD model shown in illustrations. RHD model similar.
