Charger V8-5.7L (2008)
2. Disconnect ABM harness connector from antilock brake module (ABM). To do so:
a. Depress tabs on each side of connector cover, then
b. Pull outward and upward on lower half of cover until it locks into position pointing straight outward (2). Connector can then be pulled straight
outward off ABM (1).
NOTE: DO NOT remove any brake lines from the ICU fluid ports while performing the following steps. The ABM can be removed and
installed without doing so.
3. Unclip all brake tubes from two routing clips (1) along upper radiator support.
4. Unclip right front brake tube (3) from routing clip on bracket below Fuse And Relay Center.
5. Unclip rear brake tubes (1, 2) from routing clip (3) on bracket below Fuse And Relay Center.
