Charger V8-5.7L (2008)
17. Take a measurement across the upper edge (2) of the rear glass using the vertical edges of the body opening as the reference points.
18. Divide the upper measurement in half and mark that dimension on the glass using a grease pencil or equivalent. This is the upper centerline of the
glass.
19. Take a measurement across the lower edge (1) of the glass using the vertical edges of the body opening as the reference points.
20. Divide the lower measurement in half and mark that dimension on the glass using a grease pencil or equivalent. This is the lower centerline of the
glass.
21. Connect the top center mark and the lower center mark and mark a straight line (3) for the center of the glass.
SET UP AIM BOARD AND TRIPOD
AIMING BOARD SET UP FOR ACC
NOTE: These step's are critical to the alignment of the ACC to the vehicle, make sure that you have the correct measurement and the aiming
board is in the correct position.