Charger V8-5.7L (2008)
3. Install assembly. Make sure tabs from bracket are in slots in upper headlamp mounting bracket.
CAUTION: The hood release cable must be routed under the bracket assembly. Failure to route the hood release cable properly may pinch the
cable and make the hood release inoperable This may cause damage to the release mechanism and/or cable.
4. Position the hood release cable under bracket assembly.
NOTE: Make sure the rear mounting hole bosses are in the headlamp bracket holes before tightening bolts. Hold bracket for sensor up tight to
headlamp bracket while tightening bolts.
5. Install mounting bolts and tighten to 9 Nm (79.5 in. lbs.). Install front bolt first then rear bolts.
