Charger V8-5.7L (2008)
Seat Sensor/Switch: Service and Repair
Installation
INSTALLATION
MANUAL PASSENGER FRONT SEAT
WARNING: The Seat Weight Sensor is a sensitive, calibrated unit and must be handled carefully. Do not drop or handle roughly. If dropped or
damaged, replace with another sensor. Failure to do so may result in occupant injury or death.
WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop.
If dropped, the sensor may be inoperative, could result in occupant injury, or possibly death.
WARNING: When the seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the
seat weight sensors. If sat on and damaged, the sensor may be inoperative, could result in occupant injury, or possibly death.
1. Position the seat weight sensor onto passenger front seat riser.
2. Install the two nuts (2) holding the seat weight sensor (4) to the seat riser. Torque nuts to 40 Nm (30 ft. lbs.).
3. Connect the one electrical connector (1).
4. Install the adjuster to riser mounting bolt (3). Torque nuts to 45 Nm (33 ft. lbs.). For additional information See: Body and Frame/Seats/Service
and Repair/Seat Riser - Installation.