Charger V8-5.7L (2008)
Steering Mounted Controls Communication Module: Service and Repair
Assembly
ASSEMBLY
WARNING: To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the
clockspring passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the
clockspring and prevent the airbag system from operating properly.
1. Position the Steering Control Module (SCM) onto the multi-function switch.
2. Install the multi-function switch and SCM in the SCCM shroud and tighten the three screws (1) from the bottom.
3. Install the speed control switch (1).