Charger V8-5.7L (2008)
8. Remove nut and bolt (2) securing tension strut (1) to engine cradle (3).
9. Slide tension strut out of cradle bracket and remove from vehicle.
Installation
INSTALLATION
NOTE: If installing a tension strut engine cradle bolt that is a wheel alignment adjustment bolt (lengthwise grooved shaft (2)), make sure to
install it in the same position which it was in upon removal. For more details on installation of this special bolt, See: Alignment/Service and
Repair.
1. Slide bushing end of tension strut (1) into cradle bracket (3).
2. Install mounting bolt (2) from front through cradle and bushing.
3. Install nut (2), but do not tighten at this time.