Charger V8-5.7L (2008)
Installation
INSTALLATION
1. Pierce the new transmission fill tube seal along the molded "Y" from the outside.
NOTE: If the new fill tube seal can not be fully installed into the transmission case fill tube bore by hand, a "C" clamp must be used.
CAUTION: Do not over tighten the "C" clamp during fill tube oil seal installation. Transmission oil pan damage or bending may occur.
2. Lubricate the new transmission fill tube seal with MOPAR(R) ATF+4 ATF and install the new fill tube seal into the transmission case fill tube
bore.
a. Position seal installer disc 9902 (1) between the "C" clamp (2) and the new transmission fill tube seal
b. Position a shim stock (3) between the "C" clamp (2) and the edge of the transmission oil pan.
c. Lightly tighten the "C" clamp until the fill tube seal is fully installed into the transmission case fill tube bore.
3. Clean and lubricate the end of the transmission fill tube with MOPAR(R) ATF+4 ATF and install the fill tube into the transmission case fill tube
bore.
