Charger V8-5.7L (2008)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft - Removal
Front
REMOVAL - FRONT
1. Place gearshift lever in NEUTRAL and raise vehicle on hoist.
2. Remove propeller shaft heat shield.
3. Apply alignment index marks on the propeller shaft and front axle flanges.
4. Remove and discard four front propeller shaft-to-axle flange bolts (2).
5. Apply alignment index marks on the propeller shaft and transfer case flanges.
6. Remove and discard four front propeller shaft-to-transfer case flange bolts (2).
7. Remove propeller shaft assembly (1).
Rear
REMOVAL - REAR
CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only
connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage may occur to
the shaft, coupler, and/or center bearing from over-angulation. This may result in driveline vibrations and/or component failure.
