Charger V8-5.7L VIN H (2007)
8. Position the two locator pins (4) on the back of the trim panel (2) to the locator holes (3) on the inside of the door panel and simultaneously push
the three upper pins (1) into the grommet plugs near the top of the door. Make certain that the upper edges of the trim panel are engaged in the
grooves of the window moldings.
9. Install and tighten the screw (4) that secures the interior remote handle recess of the trim panel (2) to the inside of the door (1). Tighten the screw
to 2 Nm (16 in. lbs.). Fold and snap the screw cap over the screw.
10. Install and tighten the screw (5) that secures the trim panel (2) to the pull cup bracket below the trim panel pull cup. Tighten the screw to 2 Nm (16
in. lbs.). Fold and snap the screw cap over the screw.
11. Install the three push-pin retainers (1) that secure the trim panel to the inside of the door.
12. Install and tighten the four screws (6) that secure the bottom and front lower corner of the trim panel to the inside of the door. Tighten the screws
to 2 Nm (16 in. lbs.).
