Charger V8-5.7L VIN H (2007)
1. Check to be certain that the ball stud (3) on the top of the fender load beam is in good condition and properly installed. Tighten the ball stud to 28
Nm (21 ft. lbs.).
2. Position the ball socket on the rod end of the support cylinder (1) to the ball stud on the top of the fender load beam.
3. Check to be certain that the ball stud (1) secured by a U-nut (3) to the upper bracket (2) of the hood hinge is in good condition and properly
installed. Tighten the ball stud to 28 Nm (21 ft. lbs.).
4. Position the ball socket on the cylinder end of the support cylinder (4) to the ball stud on the upper bracket of the hood hinge.
5. Using hand pressure, press the ball socket onto the ball stud until the retainer clip snaps into place.
6. Inspect to be certain that the retaining clip on each of the support cylinder ball socket ends is fully seated.
7. Remove the service prop or block and close the hood.
