Charger V8-5.7L VIN H (2007)
grooves of the window moldings.
9. Install and tighten the screw (4) that secures the interior remote handle recess of the trim panel (2) to the inside of the door (1). Tighten the screw
to 2 Nm (16 in. lbs.). Fold and snap the screw cap over the screw.
10. Install and tighten the screw (5) that secures the trim panel (2) to the pull cup bracket below the trim panel pull cup. Tighten the screw to 2 Nm (16
in. lbs.). Fold and snap the screw cap over the screw.
11. Install the three push-pin retainers (1) that secure the trim panel to the inside of the door. .
12. Install and tighten the four screws (6) that secure the bottom and front lower corner of the trim panel to the inside of the door. Tighten the screws
to 2 Nm (16 in. lbs.).
NOTE: For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required
whenever power to the door module is disrupted.A battery reconnect procedure must be performed anytime the battery has been
disconnected. See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
13. Reconnect the battery negative cable.
