Charger V8-5.7L VIN H (2007)
Seat Heater: Testing and Inspection
Front Seats
Diagnosis And Testing
HEATED SEAT SYSTEM
In order to obtain conclusive testing, the heated seat system and the Controller Area Network (CAN) data bus circuit must be checked. Any diagnosis of
the heated seat system should begin with the use of a scan tool.
Refer to the appropriate wiring information for complete circuit schematic or connector pin-out information.
NOTE: Vehicles equipped with the heated seat option utilize a low voltage cut-off feature. This feature turns off power to the heated seat system
anytime vehicle voltage is below 11.1v or above 15.5v. Be certain to check the vehicle electrical system for proper voltage anytime the power seat
system appears inoperative.
Before any testing of the power seat system is attempted, the battery should be fully-charged.
Heater-Cushion Pad
HEATED SEAT ELEMENT
Refer to the appropriate wiring information for complete circuit schematic or connector pin-out information.
The wire harness connectors (2&3) for the heating elements are located under the seat (1).
NOTE: When checking heated seat elements for continuity, be certain to move the heating element being checked. Moving the element, such as sitting
in the seat will eliminate the possibility of an intermittent open in the element which would only be evident if the element was in a certain position.
Failure to check the element in various positions could result in an incomplete test.
1. Locate and disconnect the seat electrical connector.
2. Check the resistance between the circuit leading in and out of the suspect heated seat element. The resistance should be between 3.8 - 4.8 ohms
for a seat cushion element and 4.3 - 5.4 ohms for a seat back element. If OK, Refer to Seat Heater testing. If not OK, replace the inoperative
heated seat element.
