Charger V8-5.7L VIN H (2007)
CAUTION: When seating dust boots in following step, use care not to over-install boots or damage will occur. Each boot (2) will bottom
in the counterbore before the top of the boot reaches the surface of the caliper. The boot will bottom with approximately 2 mm (1/16 inch)
(3) of boot still showing above caliper housing.
5. Seat dust boots (3) in caliper counterbores using Installer (2), Special Tool 9315, with Handle (1), Special Tool C-4171. Install each dust boot
until it bottoms. Do not over-seat dust boot or damage will occur.
6. Install caliper bleeder screw (2) in caliper housing (1). Tighten bleeder screw to 15 Nm (125 in. lbs.) torque.
7. Install caliper on vehicle.
Disassembly
DISASSEMBLY
