Charger V8-5.7L VIN H (2007)
Brake Master Cylinder: Procedures
MASTER CYLINDER BLEEDING
CAUTION: When clamping master cylinder in vise, only clamp master cylinder by its mounting flange. Do not clamp master cylinder piston
rod, reservoir, seal or body.
1. Clamp master cylinder in a vise.
CAUTION: When installing Adapters in master cylinder, do not overtighten. Damage to master cylinder could occur.
NOTE: Adapters 9748-1 and 9748-2 are not interchangeable. To avoid mix-up of Adapters, 9748-1 is silver while 9748-2 is black.
2. Attach special tools for bleeding master cylinder in following fashion:
a. Thread Adapter (3), Special Tool 9748-2, into primary outlet port. Tighten Adapter to 14 Nm (124 in. lbs.).
b. Thread Adapter (4), Special Tool 9748-1, into secondary outlet port. Tighten Adapter to 14 Nm (124 in. lbs.).
c. Thread a Bleeder Tube (2), Special Tool 8358-1, into each Adapter. Tighten each tube to 14 Nm (124 in. lbs.). Flex each bleeder tube and
place open end into mouth of fluid reservoir as far down as possible.
NOTE: Make sure open ends of bleeder tubes stay below surface of brake fluid once reservoir is filled to proper level.
3. Fill brake fluid reservoir (1) to the MAX level with Mopar(R) brake fluid or equivalent conforming to DOT 3 specifications. Make sure fluid level
is above tips of bleeder tubes in reservoir to ensure no air is ingested during bleeding.
