Charger V8-5.7L VIN H (2007)
NOTE: The horizontal M10 fasteners are 5 mm longer in length, and must be reinstalled in original locations.
23. Remove the M10 fasteners (vertical and horizontal) from the rear of the oil pan to the transmission and engine.
24. Remove the oil pan mounting bolts and oil pan.
NOTE: When the oil pan is removed, a new oil pan gasket/windage tray assembly must be installed. The old gasket cannot be reused.
25. Discard the integral windage tray and gasket and replace.
Installation
INSTALLATION
1. Clean the oil pan gasket mating surface of the block and oil pan.
NOTE: Mopar(R) Engine RTV must be applied to the 4 T-joints, (area where front cover, rear retainer, block, and oil pan gasket meet).
The bead of RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint locations.
