Charger V8-5.7L VIN H (2007)
Muffler: Service and Repair
Installation
INSTALLATION
1. Position front exhaust pipe module clamps (2) on exhaust pipe assembly.
2. Install exhaust pipe assembly into catalytic converters (3 and 4).
NOTE: Isolators will have an approximately 10° forward angle when installed.
3. Install isolators.
4. 5.7L/6.1L Engine - Install LH rear resonator and tailpipe assembly.
NOTE: Check for proper alignment and clearance to underbody and engine compartment components before tightening clamps.
5. Tighten band clamps to 61 Nm (45 ft. lbs.).