Charger V8-5.7L VIN H (2007)
NOTE: The air distribution housing must be removed from the HVAC housing and disassembled for service of the mode-air and blend-air doors.
1. Position the air distribution housing (1) into the vehicle.
2. Install the air distribution housing onto the rear of the HVAC housing (2) by inserting the tabs on the bottom of the distribution housing into the
slots located on the bottom of the HVAC housing and tipping the distribution housing forward until it is properly aligned with the HVAC housing.
3. Connect the floor distribution ducts to the air distribution housing.
4. Install the screws (3) that secure the air distribution housing to the HVAC housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Carefully install the heater core (4) into the driver side of the HVAC air distribution housing (2) and position the heater core tubes (6) to the
HVAC housing (9).
6. Install heater core retaining bracket (3) onto the air distribution housing and install the retaining screw (5). Tighten the screw to 2.2 Nm (20 in.
lbs.).
7. Install the flange (7) over the heater core tubes and onto the HVAC housing and install the two flange retaining screws (8). Tighten the screws to
2.2 Nm (20 in. lbs.).
8. On LHD models, install the blend door actuator (1) to the driver side of the air distribution housing.
