Charger V8-5.7L VIN H (2007)
NOTE: When tightening lower shock clevis mounting bolt, do not attempt rotating bolt. Bolt shaft is serrated. Turn nut only.
11. Tighten lower shock clevis bracket bolt nut (3) to 174 Nm (128 ft. lbs.).
12. Perform wheel alignment.
CAUTION: If lower control arm engine cradle bolt is a wheel alignment adjustment bolt (lengthwise grooved shaft (2)), be sure to only
tighten nut. Do not rotate bolt or damage to cradle will occur.
13. Once camber is found to be within specifications, tighten lower control arm cradle bolt nuts to 176 Nm (130 ft. lbs.) while holding the bolts
stationary.
14. Install belly pan.
Removal
REMOVAL
1. Raise and support vehicle.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).