Charger V8-5.7L VIN H (2007)
15. Remove two pressure line retainer bolts (1) from cradle (2).
16. Remove mounting screws, then heat shield (3) above each inner tie rod bellows (2).
17. Remove steering gear upper mounting bolt (4) and nut.
18. Remove steering gear lower mounting bolts (2 and 3).
19. Remove steering gear (1) and support from the exhaust system.
20. Loosen nut (4) attaching lower control arm ball joint stud to knuckle (3). Back nut off until nut is even with end of stud. Keeping nut on at this
location will help keep end of stud from distorting while using Puller in next step.