Charger V8-5.7L VIN H (2007)
side of caliper) are completely bottomed in bores of caliper half.
NOTE: Repeat above procedure to opposite brake pad (1) and pistons as necessary.
14. If equipped with SRT8 disc brakes, on each rear disc brake, support spring link (1) using a transmission jack (5) or other appropriate jack. Raise
spring link just enough to access brake caliper lower mounting bolt (4) from above compression link (2).
15. If equipped with SRT8 disc brakes, on each rear disc brake, remove the lower and upper caliper mounting bolts (1).
16. If equipped with SRT8 disc brakes, on each rear disc brake, remove brake caliper (2) with pads from knuckle and brake rotor. Hang assembly out
of way using wire or a bungee cord. Use care not to overextend brake hose when doing this.
17. If equipped with SRT8 disc brakes, remove jack from under spring link.
