Charger V8-5.7L VIN H (2007)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
10. Using Puller (2), Special Tool 9360, separate ball joint stud from knuckle.
11. Remove tool.
12. Remove nut (1) from end of ball joint stud.
13. Loosen nut (4) attaching upper ball joint stud (1) to knuckle. Back nut off until nut is even with end of stud. Keeping nut on at this location will
help keep end of stud from distorting while using Puller in next step.
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
14. Using Puller (2), Special Tool 9360, separate upper ball joint stud (1) from knuckle.
15. Remove tool.
16. Remove nut (1) from end of upper ball joint stud.
