Charger V8-5.7L VIN H (2007)
NOTE: If equipped with AWD, when removing crossmember mounting bolts in following step, be sure to not to misplace spacers (1)
between crossmember mounts (2) and body.
25. Remove both front (3) and both rear (2) mounting bolts fastening crossmember (1) in place.
26. Slowly lower crossmember using jack. Do not lower jack at a fast rate. Lower just enough to allow propeller shaft removal from rear axle
differential. Do not lower jack any further than necessary. Slide propeller shaft out of rear axle differential and allow bungee cord previously
installed to support.
27. Continue to lower jack until crossmember is at a comfortable working level to access stabilizer bar fasteners.
28. On each end, remove bolt (3) and nut fastening stabilizer bar (4) to stabilizer link (2).
29. Remove bolts (1) fastening each stabilizer bar isolator retainer to crossmember.
30. Remove stabilizer bar (4) with isolators and retainers.
31. Remove retainers from isolators.
32. Remove isolators from stabilizer bar utilizing slits in bushings.
