Charger V8-5.7L VIN H (2007)
7. Install the water shield (1) and water shield bolts (2) (if equipped).
8. Tighten the water shield bolts to 12 Nm ( 9 ft.lbs).
9. Lower vehicle to check and fill transmission as necessary.
Removal
REMOVAL
1. Remove the propeller shaft. Move propeller shaft to the right and tie up.
2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
NOTE: When removing the propeller shaft flange be certain the shim remains on the output shaft.
3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
4. Remove the output shaft seal with suitable screw and slide hammer.
Installation
INSTALLATION
1. Position the new output shaft seal over the output shaft and against the transmission case.
2. Use Seal Installer 8902A (1) to install the seal.
