Charger V8-5.7L VIN H (2007)
Constant Velocity Joint Boot: Service and Repair
Boot-CV Inner
Removal
REMOVAL
1. Remove large boot clamp which retains inner tripod joint sealing boot to tripod joint housing and discard. Remove small clamp which retains inner
tripod joint sealing boot to interconnecting shaft and discard. Remove the sealing boot (3) from the tripod housing and slide it down the
interconnecting shaft.
CAUTION: When removing the tripod joint housing from the spider assembly, hold the bearings in place on the spider trunnions to
prevent the bearings from falling away.
2. Slide the tripod joint housing (1) off the spider assembly and the interconnecting shaft.
3. Remove snap ring (3) which retains spider assembly to interconnecting shaft (1). Do not hit the outer tripod bearings in an attempt to remove
spider assembly from interconnecting shaft.
