Charger V8-5.7L VIN H (2007)
13. Clean the backlite fence with an ammonia based glass cleaner and a lint-free cloth.
14. Apply pinch weld primer 15 mm (0.75 in.) wide (1) around the backlite fence (2). Allow at least three minutes drying time.
15. Using a flashlight, verify that the primer is completely and evenly installed along the backlite fence.
16. Re-prime any area that is not fully and evenly primed.
CAUTION: Always apply the bead of adhesive to the backlite. Always install the backlite within 5 minutes after applying the adhesive.
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
17. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive (1) with a triangular nozzle approximately 6 mm (0.230 in.) from the edge of the
glass (2) starting at the bottom center of the backlite.
18. Run the end of the adhesive bead (1) on the backlite (2) parallel to the start of the bead and smooth the ends flush.
