Charger SRT-8 V8-6.1L VIN W (2006)
WARNING: Do not use solvent based glass cleaners to clean the liftgate glass before applying glass prep and primer or poor glass
adhesion may result.
8. Clean the inside of the liftgate glass with an ammonia based glass cleaner and a lint-free cloth.
9. Apply glass prep adhesion promoter 25 mm (1 in.) wide (1) around the perimeter of the liftgate glass (2) and 5 mm (0.2 in.) from the edge of the
glass and wipe dry with a clean lint-free cloth until no streaks are visible.
10. Apply glass primer 25 mm (1 in.) wide around the perimeter of the liftgate glass and 5 mm (0.2 in.) from the edge of the glass. Allow at least
three minutes drying time.
11. Using a flashlight, verify that the primer is completely and evenly installed along the perimeter of the liftgate glass.
12. Re-prime any area that is not fully and evenly primed.
13. Clean the liftgate glass fence with an ammonia based glass cleaner and a lint-free cloth.
14. Apply pinch weld primer 15 mm (0.75 in.) wide (1) around the liftgate glass fence (2). Allow at least three minutes drying time.
15. Using a flashlight, verify that the primer is completely and evenly installed along the liftgate glass fence.
16. Re-prime any area that is not fully and evenly primed.
CAUTION: Always apply the bead of adhesive to the backlite. Always install the backlite within 5 minutes after applying the adhesive.