Charger SRT-8 V8-6.1L VIN W (2006)
-
(6) Installer 9520-2
-
(7) Thrust Bearing
3. Insert Installer (6) into end of bushing and Disc (2) into opposite end of crossmember bushing bore.
4. While holding Nut (4) from rotating, tighten Bolt (1) using hand tools, pressing bushing into crossmember. Stop when Installer (6) bottoms against
bushing bore.
5. Remove tools.
CAUTION: Differential mounting bolts (1) must be installed through bushings prior to crossmember installation in vehicle. Bolts cannot
be inserted through bushings once crossmember is installed.
6. Insert differential mounting bolt (1) through mount bushing from rear (198 mm axle differential shown in figure. Other axles differ, but similar).
NOTE: Do not install coil springs on spring links at this time.
7. Raise crossmember to body mounting points. As crossmember is raised, align shocks (3) with pockets in spring links. Do not install bolts at this
time.