Charger SRT-8 V8-6.1L VIN W (2006)
4. On the driver side only, install the push-pin fastener (3) that secures the inboard edge of the front carpet (1) to the transmission shifter bracket (2).
5. Reinstall the trim onto the driver or passenger side lower cowl side inner panel as appropriate.
6. Reinstall the center console onto the front floor panel transmission tunnel.
7. Reinstall the driver and/or passenger front seat into the vehicle as appropriate.
REAR
1. Position the rear carpet (3) into the vehicle through one of the rear door openings.
2. Pull the body wire harness take outs and connectors through the appropriate slits in the rear carpet.
3. Fit the rear carpet to the floor panel. Be certain to align the holes in the carpet with the corresponding holes in the floor panel. Be certain that the
rear edge of the carpet is fitted over the rear seat kick-up area and over the rear seat cushion cups on the top of the kick-up area. Be certain that the
front edge of the carpet is fitted over the front seat rear crossmember and butts up against the rear of the front seat front crossmember.
4. Install the push-pin fasteners (2) that secure the outboard edges of the rear carpet near the front of each rear door opening (1) sill.
5. Reinstall the scuff plate onto both rear door sills.
6. Reinstall the rear seat cushion into the vehicle.
7. Reinstall the trim onto the inside of both lower B-pillars.
8. Reinstall the center console onto the front floor panel transmission tunnel.
9. Reinstall the driver and passenger front seats into the vehicle.
TRUNK - SEDAN
