Charger SRT-8 V8-6.1L VIN W (2006)
11.
Shift magnet base to one edge of opening as shown in (Fig. 5) so magnet base can be removed. Shifting magnet to one side may require breaking a
glue bond between magnet base, white foam, and headliner, or some combination thereof.
12.
Before installing new magnet/base assembly, p/n 05191198AA, remove the backing from mylar patch to expose the adhesive and center the mylar
on magnet disc. Press all four corners of the mylar down to the black plastic post of the base.
13.
Install the new magnet/base assembly and replace the square section of white foam. No glue is required.
14.
Remove the remaining film covering the pressure sensitive adhesive from the hook & loop fasteners.
15.
Cover the palm of your hand with a clean lint free cloth or glove then push the headliner up to contact the roof. Apply 15 pounds pressure for 5
seconds at each fastener location.
16.
Return the rear seat backs to their upright and latched position.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
