Charger SRT-8 V8-6.1L VIN W (2006)
1. Engage the seat belt webbing through the slit and into the slot in the upper end of the lower B-pillar trim (3) and position the trim to the inside of
the B-pillar (1). Be certain the webbing is not twisted.
2. Press fit the lower end of the lower B-pillar trim to the front and rear door opening sills.
3. Install and tighten the two screws (4) that secure the lower end of the B-pillar trim to the front and rear door sills. Tighten the screws to 2 N.m (22
in.lbs.).
4. Move aside the seat belt webbing to install and tighten the two screws (2) that secure the upper end of the lower B-pillar trim to the inside of the
B-pillar. Tighten the screws to 2 N.m (22 in.lbs.).
5. Reinstall the scuff plate trim onto the rear door sill.
6. Reinstall the lower cowl trim onto the front door opening sill.
UPPER
1. Engage the locator tab (2) on the back of the upper trim (4) into the locator hole on the inside of the B-pillar (3).
2. Align the two spring clip retainers on the trim with the slots in the inner B-pillar.
3. Using hand pressure, press firmly and evenly on the trim over each of the spring clip locations until the retainers snap into place.
4. Install and tighten the screw (1) that secures the lower end of the upper trim to the inside of the B-pillar. Tighten the screw to 3 N.m (25 in.lbs.).
