Charger SRT-8 V8-6.1L VIN W (2006)
Brake Pad: Service and Repair
PADS - FRONT/REAR BRAKE - SRT8
STANDARD PROCEDURE
BRAKE PAD BURNISHING
CAUTION: After installing NEW brake pads, keep in mind that braking effectiveness might be somewhat reduced during the first brake applications.
When NEW brake pads are installed on a vehicle, this procedure must be used to correctly burnish (seat) the brake linings to the brake rotor discs.
1. Accelerate the vehicle to a steady speed of about 40 mph (65 km/h).
2. Using light brake pedal pressure, slow the vehicle from 40 mph to 0 mph in approximately 6 seconds.
3. Accelerate back up to 40 mph for approximately one minute to allow the brakes to cool down.
4. Repeat this procedure 15 to 20 times to correctly seat the brake lining material.
REMOVAL
NOTE: Review all Warnings and Cautions.
1. Raise and support vehicle.
NOTE: Perform Step 2 through Step 8 on each side of vehicle to complete pad set removal.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
3. Using hammer (4) and pin punch (3) on outboard end, tap lower brake pad support pin (2) out of caliper (1).