Charger SRT-8 V8-6.1L VIN W (2006)
9. Once support pins are fully installed into caliper, inspect assembled caliper to make sure spring clip (2) is centered in opening (1) of caliper,
correctly engaging upper and lower support pins, and is resting against both brake pads (3).
10. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
11. Lower vehicle.
12. Pump brake pedal several times to set pads to caliper and brake rotor.
13. Check and adjust brake fluid level in reservoir (1).
CAUTION: When NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first
brake applications following installation.