Charger SRT-8 V8-6.1L VIN W (2006)
11. If hub runout does not exceed this specification, install original rotor back on hub, aligning chalk mark on rotor (2) with a wheel mounting stud,
two studs apart from original stud (1).
12. Install standard wheel mounting nuts, flat side to rotor, on all studs (2). Progressively tighten nuts to 150 Nm (110 ft. lbs.) torque.
13. Mount Dial Indicator (1) and remeasure runout on both sides of the brake rotor as explained in earlier steps to see if runout is now within
specifications.
14. If runout is still not within specifications, reface or replace brake rotor.
