Charger SRT-8 V8-6.1L VIN W (2006)
CAUTION: Seal on rear of master cylinder (2) is used to allow vacuum ability in power brake vacuum booster. Vacuum seal on master cylinder
MUST be replaced whenever master cylinder is removed from power brake vacuum booster.
10. Remove vacuum seal located on mounting flange of master cylinder (2). Vacuum seal is removed by carefully pulling it off rear of master cylinder.
Do not attempt to pry seal off master cylinder by inserting a sharp tool between seal and master cylinder casting. Damage can occur.
DISASSEMBLY
1. Clean master cylinder housing and brake fluid reservoir. Use only Mopar® Brake Parts Cleaner or equivalent.
NOTE: SRT8 vehicles are not equipped with a master cylinder mounted pressure switch for the Electronic Stability Program. The switch is
located in the primary brake tube.
2. If equipped with Electronic Stability Program (non SRT8), remove pressure switch on bottom of master cylinder (1).
