Charger SRT-8 V8-6.1L VIN W (2006)
INSTALLATION
NOTE: Before installing booster, make sure there is a NEW booster seal (2) placed over push rod and mounting studs on rear of booster (1).
1. Install power brake booster through opening between cross-brace and windshield. Guide booster (1) push rod and mounting studs through dash
panel (2).
NOTE: Be sure to tighten all four booster mounting nuts to specifications or a vacuum leak can result.
2. Install four power brake booster mounting nuts (4). Tighten nuts to 25 Nm (18 ft. lbs.) torque.
