Charger SRT-8 V8-6.1L VIN W (2006)
8. Tap piston down in cylinder bore using a hammer handle. While at the same time, guide connecting rod into position on rod journal.
CAUTION: Always replace the Rod Bolts whenever they are loosened or removed.
9. Lubricate rod bolts and bearing surfaces with engine oil. Install connecting rod cap and bearing. Tighten bolts to 45 Nm (33 ft. lbs.) plus a 60°
turn.
10. Install the following components: Cylinder head(s). Cylinder head covers. Install the intake manifold. Oil pan and gasket/windage tray.
11. Fill crankcase with proper engine oil to correct level.
12. Connect negative cable to battery.
