Charger SRT-8 V8-6.1L VIN W (2006)
WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE
FOLLOWING OPERATION. FAILURE TO FOLLOW THE WARNINGS AND CAUTIONS COULD RESULT IN POSSIBLE PERSONAL
INJURY OR DEATH.
1. Disconnect and isolate the negative battery cable.
2. Remove the cowl top panel from the dash panel.
3. Remove the two bolts (1) that secure the strut support (2) to the driver side strut tower (3).
4. Disengage the wiper motor (5) from the bracket (4) located on the strut support.
5. Disengage the retainer that secures the wire harness (4) to the bottom of the strut support (3).
6. On LHD models, remove the purge solenoid (5) from its mounting bracket and position the solenoid out of the way.
7. Remove the two bolts (1) that secure the strut support to the passenger side strut tower (6) and remove the support from the engine compartment.
8. Position the powertrain control module (PCM) or the engine control module (ECM) (2) (depending on engine application) out of the way.
