Charger SRT-8 V8-6.1L VIN W (2006)
Trunk Lamp: Service and Repair
LIFTGATE LAMP
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open liftgate.
3. Using a trim stick (3) (special tool #C-4755) or equivalent, gently pry out on liftgate lamp lens (2) and remove from trim panel (1).
4. Gently pry up on the edge of the affected lamp and pull out of the liftgate lamp unit to remove.
INSTALLATION
1. Place new lamp over retaining clips in liftgate lamp unit retaining clips and firmly snap into place.