Charger SRT-8 V8-6.1L VIN W (2006)
CAUTION: Before tightening sensor mounting bolt (3), be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to
sensor mounting tang may result.
4. Install mounting bolt (3) and tighten to 12 N.m (106 in. lbs.) torque.
5. Connect electrical connector (2) to sensor.
6. IF STARTER IS MOUNTED TO RIGHT SIDE OF ENGINE: Install starter motor.
7. Lower vehicle.
8. IF STARTER IS MOUNTED TO RIGHT SIDE OF ENGINE: Install negative battery cable.
