Charger SRT-8 V8-6.1L VIN W (2006)
3. Disconnect knock sensor electrical connector (5).
4. Remove sensor mounting bolt (2). Note foam strip on bolt threads. This foam is used only to retain the bolts to sensors for plant assembly. It is not
used as a sealant. Do not apply any adhesive, sealant or thread locking compound to these bolts.
5. Remove sensor from engine.
INSTALLATION
1. Thoroughly clean knock sensor mounting hole.
2. Install sensor (1) onto cylinder block.
NOTE:
-
Over or under tightening the sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control. Always
use the specified torque when installing the knock sensors. The torque for the knock senor bolt is relatively light for an 8mm bolt.
-
Note foam strip on bolt threads. This foam is used only to retain the bolts to sensors for plant assembly. It is not used as a sealant. Do not
apply any adhesive, sealant or thread locking compound to these bolts.
3. Install and tighten mounting bolt (2).
4. Install electrical connector (5) to sensor.
