Charger SRT-8 V8-6.1L VIN W (2006)
5. Connect the voltmeter to measure between the battery negative cable eyelet terminal connection at the right front strut tower and the battery
negative cable eyelet terminal connection at the transmission housing. Rotate and hold the ignition switch in the Start position. Observe the
voltmeter. If the reading is above 0.2 volt, clean and tighten the battery negative cable eyelet terminal connection at the right front strut tower.
Repeat the test. If the reading is still above 0.2 volt, replace the battery front negative cable.
6. Using a suitable jumper wire, connect the voltmeter to measure between the battery positive cable terminal clamp and the starter solenoid B(+)
terminal stud. Rotate and hold the ignition switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten
the battery positive cable eyelet terminal connection at the starter solenoid B(+) terminal stud. Repeat the test. If the reading is still above 0.2 volt,
perform Step 7 and Step 8.
